Dictate the summary of this article:
If your ProDVX panel has GoBright pre-installed but you have no requirement to use this application, you can remove it from the panel.
Completion Time: ~5-10mins
Fire up the panel and wait for the GoBright application to
load. You will be presented with an activation code.
Ignore the activation and perform
the following gesture on screen to exit the kiosk.
Removing your finger after each motion:
This now takes you into the Android settings interface. You will not be prompted for a PIN as the
device has not been activated.
Under the Device section, select Exit and
confirm the pop-up
Swipe down twice / three times from the top of the screen
and press the settings cog
Find the Device section, select Apps and then
find GoBright - Device
Select this option and select Force Stop. On the same
page, press Uninstall and confirm the pop-up.
Now, on the bottom toolbar, press the triangle back icon 2
or 3 times to return to the home screen.
After the above steps above have been carried out, GoBright
has been uninstalled and you have a blank ProDVX panel.
Now use the devices web browser to download the .apk file of
your choice and install the relevant package. You also have the option of
installing the .apk file from a USB device.
Important: If you’re using a USB device, it must be
formatted as FAT32. NTFS is not supported.
If you have any questions, please log a support ticket by contacting Ascentae Support.